Master Sword Terminal for Transformers TR Fortress Maximus 3D print model

Adding on to the previous Master Sword ( https://www.patreon.com/posts/53215208 ), here's the terminal which holds it in place (for charging?) before Cerebos/Fortress is able to pull it out for his transformation.

This set is sized to fit on a CyberBase System Core Set base tile ( https://www.patreon.com/posts/33140482 ) and features a swivel arm which holds the Master Sword in place.

Once, it has been charged up, the arm will rotate downwards to release it and it can be drawn out to begin the transformation process!

The terminal pegs onto the base tile using a pair of 10mm diameter pegs which are also included in the set.

=== ASSEMBLY ===

Putting this all together is fairly simple, as the main piece is comprised of a front and rear section. This was planned to make printing it not take too long. The two halves then peg together using 5mm peg.

The arm attaches to the twin connector points on the front portion using the provided 5mm peg too.

===

Being Cyberbase compatible, these can extend into a large display. So hope you all have fun with getting this 3d printed out, and looking forward to seeing what everyone does with it! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog