Digital 3D printable model of a cute Halloween bat. The model is a flying mobile – a toy that flaps its wings.

ASSEMBLY

• Apply pressure to the wings to free the hinges
• Connect the ears, yellow eyes and body using a little glue.-Cut two pieces of fishing line of the same length. I used 2 x 90 cm.
• Run the fishing line through the holes in the wings from the bottom and then through the hole in the bar above. Tie a knot at the top and tuck the ends of the knot into the side slit.
• Repeat on the other side.
• Then just tie the bead to the hole in the belly of the bat using another piece of fishing line.

3D PRINTER SETTINGS

• supports on the head and ears
• 0.15 mm layer height
• 15% infill
• 3 mm brim

This is a digital 3D printable model. Do you like the model and don’t have a 3D printer? There are lots of people who offer 3D printing services these days. Try searching for someone who offers them in your area.

This fan-made model was brought to life by 3Demon. We are a group of modeling and 3d printing enthusiasts based in Prague, Czech Republic. We’ve been making 3D printable models for more than a decade. We make a lot of cosplay accessories but we also make all sorts of interesting 3D models.