Energon Stars from Transformers Energon 3D print model

Energon stars were a fun little gimmick from the Energon installment of the Unicron Trilogy.

Sporting two distinctive looks for the Autobots and Decepticons, these were mined or dug out by their respective omnicons, to be shot towards any bot to power them up.

These new printable ones have been designed with a few versions - one set of which can be used as replacements in case your originals from back in the day have been lost.

Also, to modernize their use for the more recent Transformers, variants which fit onto 3mm effect pegs or be attached into 5mm ports are also provided.

So now, your old school omnicons like Strongarm can shoot and power up the more modern versions of the Autobots, while Divebomb does the same for the evil Decepticons!

Here are the various types of backs for the Energon Stars. Those designed to fit onto 3mm effect pegs have versions with the ports offset as effect pegs seem to go in all sorts of off-center locations!

Hope y'all enjoy this little blast from the past - happy 3d printing as always! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog