The DC Animated Universe Aquaman Trident. Moderately modified for practicality. Also included is a Comic Con Version (points and blades dulled) - shaft is universal for both normal and comic con versions. This model was printed and tested to make sure it works!

71" tall ||| 6 parts (1x head, 4x shaft, 1x tail) ||| About 95 hours to print all pieces

Recommented Printing Instructions:

• The Head: Print flat on the bed with supports. Atleast 20% infill. Atleast 75% infill for 30mm of the connection joint and the connection point between the central spike and the rest of the trident
• The Shaft: Print vertically (standing up) with a good brim and no supports. Atleast 20% infill. Atleast 75% infill for 40mm of both the top and bottom connection joints
• The Tail: Print vertically (standing up) with a good brim and no supports. Atleast 20% infill. Atleast 75% infill for 40mm of the connection joints and 20mm of the point at the bottom of the trident

Remember to clean between prints, and put some glue stick down to ensure proper adhesion. Should not topple with proper adhesion

Finishing:

This should be mostly plug and play. The screws should be snug and not very tight, if its too tight, take a knife and carve the mouth of the female piece a little wider. If you have any questions, let me know!

With all that done, you can get back to being the proper King/Queen of Atlantis.