CyberBase System - Garage Base Tile Display for Transformers 3D print model

Transformers being what they are, may choose to hang out in their alt modes occasionally. Or perhaps, you've just ran out of a teensy bit of shelf space for them all.

So, here's an alternative to displaying and showcasing your bots' vehicular alt mode in a Cyberbase compatible setup!

The main piece for this set is the garage base tile, upon which a circular turntable is placed. This turntable section rotates in place so there won't be a need for your bots to have to back out to get off the tile.

There should be ample space to nicely display a deluxe sized figure, or even some of the smaller masterpiece bots. To add a rear wall for a bit of verticality, the walls and shorter pillars from this set would work nicely - https://www.patreon.com/posts/43279697

With 5mm diameter magnets optionally added around the base of the tile, the included 'ramp" connector piece can be attached to the middle of the tile. This allows for a connection point to any of our CyberBase Track pieces (https://www.patreon.com/posts/35603475) or to other figures which sport a TR or WFC connector point:

==

Now, we 've only just printed and painted up a single piece to make sure everything works nicely - but this should be a fun set to create many parking lots with. So, have fun with this one, and looking forward to seeing how everyone setups their garage-themed displays ;)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog