I'm not good at painting so my goal with this Cartoon Rocket was to design something that didn't required painting while still looking great. I only used standard Cura settings in order to make it easier to print this model.

All the parts have been orientated the same way as I printed them, everything was printed on my ender 3 pro and I used CA glue to put everything together. Some cleaning of the parts printed with a brim was required, also the window has a thin edge that goes facing down and the window rivets sometimes will break of from the base so you either mount it with the base if they don't brake or just glue each rivet directly to the window.

The rocket is 15cm tall by itself and 22cm tall with the base

Hope you guys enjoy building this rocket as much as I did. If you have any comments/questions or if you need help with a design, please contact me.

/M Factory

Print Settings

Red parts:
Nose x1: Standard Quality 0.2mm setting, no supports
Window x2: Standard Quality 0.2mm setting, no supports
Fins x1: Standard Quality 0.2mm setting, brim and no supports

Gray parts:
Body rivet x12: Standard Quality 0.2mm setting, brim and no supports
Side panel x2: Standard Quality 0.2mm setting, brim and no supports
Window rivets x2: Dynamic Quality 0.16mm setting, brim and no supports
Nozzle x1: Standard Quality 0.2mm setting, brim and no supports

White parts:
Body x1: Standard Quality 0.2mm setting, no supports
Smoke x1: Standard Quality 0.2mm setting, no supports

Black parts:
Tile left x2: Standard Quality 0.2mm setting, brim and no supports
Tile top x4: Standard Quality 0.2mm setting, brim and no supports
Tile right x2: Standard Quality 0.2mm setting, brim and no supports
Tile bottom x6: Standard Quality 0.2mm setting, brim and no supports