Cane and ID Remote for Transformers WFC Bumblebee 3D print model

From the pages of the IDW comic-verse, we saw a weary Bumblebee try to keep the peace on a divided Cybertron. With a cane in one hand and and ID Chip remote in the other - the stick and the stick.

Designed specifically for WFC Cybertronian Mode Bumblebee, as he was in the comics, equip him to be ready for the toil of governance.

But at times where Bumblebee needs to get into the thick of a brawl, swap out the standard leg of the cane for this opened one crackling with energy (painted on of course) !

And just for fun, the tip of the cane in either mode is sized to fit on effect parts so he can shoot with it too!

=== Assembly ===

The included diagram shows all the parts included for this build.

Either version of the body of the cane, once printed, simply slots in snugly into the c-clip portion of the handle and should stay in place.

If it rotating part turns out a little loose, a dab of superglue left to dry can help tighten the joint.

===

Have fun 3d printing this godfather-esque set for your own WFC Bumblebee to make him more complete like we see in the comics! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog