TSUBAKI MK-II - NO MORE HEROES BEAM KATANA - COSPLAY AND FIGURE 3D print model

• All files are in STL format.

• Model printed in parts.

CUT TYPE 1 - Blade with the separate tip part to fit the beams (This type of cut contains only one STL file of the beam, as it can be printed 5 times to mount the full beam katana), plus the handle and pins.

CUT TYPE 2 - Blade splited into 3 parts with the separate tip part (splited into 2 parts) to fit the beams (This type of cut contains a beam divided into 3 STL files, each part must be printed 5 times to mount the full beam katana), plus the handle splited into 3 parts (Plus the details named HANDLE_DETAIL_x5, which means it also has to be printed 5 times) and pins.

CUT TYPE 3 - Blade splited into 3 STL files (Each of these files need to be printed 2 times) with the separate tip part (splited into 2 parts) to fit the beams (This type of cut contains a beam divided into 3 STL files, each part must be printed 5 times to mount the full beam katana), plus the handle splited into 4 STL files (Only the STL file named HANDLE_PART_3_x2 needs to be printed 2 times), plus the details named HANDLE_DETAIL_x5, which means it has to be printed 5 times and finally the pins.

UNCUT - STL blade full uncut.

Attention: The number of times that each piece must be printed is in the name of each STL file (Ex.: BEAM_x5, this means that this piece must be printed 5 times). If there is no quantity written in the STL file means that such part only needs to be printed once to mount 1 sword completely.

Size: 981mm (98cm)

This model is a dummy replica item.

• For stable 3D printing, I recommend using the Bambu Studio software.

This 3D model of the TSUBAKI MK-II was made for fans of the No More Heroes game and also for everyone who likes swords in general.

ATTENTION: All parts were cut thinking of the size of the printing bed of the 3D printers and not for each color that the part has. So the part of coloring the pieces before/ after being printed is up to the customer’s preference! If you want to hire me for any customization, please contact me through direct messages and not by the ad itself! But if there are any questions about the STL files, these can be made in the comments section, as it may be useful to other people.

For FDM of DLP/SLA tecnology

FDM Config.:

Layer height 0.2

Perimeter Shell 3

Fill 10/15%

Supports are needed

Speed 60-70%