SWORD of THORIN OAKENSHIELD - Orcrist from The Hobbit 3D print model

This is my Thorin Oakenshield Sword design. Inspired from The Hobbit. This model is made by me. I really love Thorin and elvish weapons. I will make more swords, bows, axes and wands from movies! Maybe even helmets, armours and more! Modelling time is 5 hours.

It is a 90 cm sword. You can print bigger or smaller. However you want! :) THERE ARE SMALLER PARTS FOR SMALLER PRINTERS (14x14x14cm) :) But I think actual sword size is about 100 - 110cm. The model consists of 4 parts. Handle, mid part, blade ( two parts ) and connector. 3 part blade is included in the project. For small printers! If you have a really large printer, NO SPLIT part is included, too! :) You will need support when printing some parts. Let me show my print settings.

CREALITY CR-10 PRINT SETTINGS and PRINT TIMES

Handle Part 0.1mm ( 100 micron ) %20 infill Open Support 60 Degrees Bed Heat ( for all models ) 200 degrees nozzle heat ( for all models ) Printing time is 12 hours. If you use my choice of measure.

Middle Part 0.1mm ( 100 micron ) %20 infill Open Support Printing time is 10 hours. If you use my choice of measure.

Blades Part 0.15 mm ( 150 micron ) %20 infill Close Support Printing time for each part is about 4 hours. If you use my choice of measure.

Total print time is about less than 2 days. You won't need a sandpaper or any finishing techniques if you print them with 0.1-0.15mm ( 100 - 150 micron ) Please show me when you print the models!

If you have any question about my designs or anything, please don't hesitate to write me a message! You can also send me a message for your bulk purchase to. See you on next projects!

About Orcrist Sword Quoted Orcrist was an Elven sword, the mate of Glamdring. It had a fancy scabbard and a jeweled hilt. Like Glamdring and Sting, the blade could detect the presence of Orcs and warn its bearer by glowing blue. Goblins called the blade Biter.