DRACO MALFOY WAND - HARRY POTTER 3D print model

This model made by me!
Modelling time 1 hours!
2 parts print.
There is a connector for these parts.
NO SUPPORT! JUST PRINT!
If you print 100 micron (0.1mm), you won't need sandpaper! :)

I hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message!
You can also send me a message for your bulk purchase to.
See you on next projects!

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height
%60 infill
NO SUPPORT
60 degrees Bed heat
200 degrees Nozzle heat

4 hours print time!