This is my Bellatrix Lestrange Wand design. Inspired from Harry Potter!

This model made by me! Modelling time 3 hours! It is high-resolution model. About 370.000 polygons. Three part. But full wand (without split) is included. Made in cinema 4D. NO SUPPORT! JUST PRINT! This wand is two part. You need to glue them after print. If you print 100 micron (0.1mm), you won't need sandpaper! :)

CREALITY CR-10 PRINT SETTINGS

100micron (0.1mm) Layer height %60 infill NO SUPPORT 60 degrees Bed heat 200 degrees Nozzle heat

7 hours print time!

I hope you like guys!

If you have any question about my designs or anything, please do not hesitate to write me a message! See you on next projects!

Quoted"""ABOUT BELLATRIX LESTRANGEBellatrix Lestrange (née Black) (1951 – 2 May, 1998) was a pure-blood witch, the eldest daughter of Cygnus Black III and Druella Black (née Rosier) and elder sister of Andromeda Tonks and Narcissa Malfoy. She was a member of the House of Black, an old wizarding family and one of the Sacred Twenty-Eight. Bellatrix started her education at Hogwarts School of Witchcraft and Wizardry in 1962 and was Sorted into Slytherin House.

As Hermione Granger identified this wand as the one that tortured Alice and Frank Longbottom[2], it is likely that Bellatrix Lestrange used this wand both before and after her imprisonment in Azkaban, possibly since the age of eleven. She recovered it after escaping from prison in 1996, fighting with it during the Battle of the Department of Mysteries and killing her cousin Sirius Black with it.Quoted"""