Tower of Dice-pair pushbutton D20 roller 3D print model

A dice tower like none other!

A fully functioning dice tower with a surprise. Remove the roof to load the magazine with up to twelve standard twenty sided dice* andpress the little red button (assuming you also printed the button in red) at the base of the tower and watch them fire out the front one by one.

Good rolls guaranteed!!**

*for best results use dice with more rounded off points**statistical likelyhood for good rolls is not affected. Just keep pumping out dice until this claim is true for you

Print Settings:Minimum Z axis: 220mmMaterial: Tested in PLA and PETG but I see no reason you couldn't do ABS if you wanted.Layer Height: .12mmWall Thickness: 1.6mmTop/Bottom Thickness: 1.02mmInfill: 20%Support: Yes (see below)Support Angle: 63 degreesSupport Density: 20Raft: Not required

For Tower Body and Tower Crown: support everywhereAll the rest: support touching the build plate only

General notes:1: Be gentle with the screws, they do not take much torque.2: Paper or thin cloth can be slipped into gaps between chassis and body to help reduce noise a bit, but is not required.