Hey,i made this Modell, because there are only Slaaneshis.

It took a lot of time and filament because i wanted to make it FDM-friendly and big. Sometimes Chains broke or i found out new mistakes which had to be fixed.

Now the modell is fine and i hope you enjoy it.

I sell it because it really was work and i needed a lot of patience.

There are two versions in the zip-file. There are 7 parts so you can Print the whole body or the body in parts (its easier to print and the risk to break of chains by removing supports is lower).

Leave comments, likes and share your oppinion please :)Leave critics because i want to work on all my "mistakes

Print it as usual.Print the parts in 45° so that the supports dont enclose the chains on the chest.Be sure your support-settings are good...i made two mistakes really often...supports to near and supports to wide away.