Superman cell phone or tablet holder 3D print model

Superman cell phone or tablet holder, the logo is included so you can place it wherever you want, nothing else sticks or if you want to screw it.It remains to sand and paint as soon as I finish painting it, I will upload the photoDimensions: 6.5 cm wide x 12 cm high x 12.5 cm deepParameterslayer height: 0.2mminitial layer : 0.32 mmWalls: 5top and bottom : 540% infill so that it has a good resistancefilled pattern: zigzagSpeed: 45mm/ssupport: tree, important since that depends on how it will come outPlace the piece on the flat side of the cell phone holder, seen from the front, the superman place the left part on the printer bed.If you want to place it vertically, it is your decision, since lying down it has more resistance to impact or pulls and vertically, the superman face will turn out well and you will not sand much anymorePortacelular o porta tableta de superman, se incluye el logo para que lo coloques donde quiera, nada mas se pega o si quieres atornillar. Falta lijar y pintar en cuanto lo termine de pintar subo la foto Dimensiones: 6.5 cm de ancho x 12 cm de alto x 12.5 cm de profundidad Parametros altura de capa: 0.2mmcapa inicial : 0.32 mmParedes: 5 superior e inferior : 5relleno 40% para que tenga una buena resistencia patron relleno: zigzagVelocidad: 45 mm/ssoporte: de arbol , importante ya que eso depende como va a salir Colocar la pieza del lado plano del portacelular, visto de frente el superman colocar la parte izquierda en la cama de la impresora. Si lo quieres colocar de manera vertical es tu decision, ya que acostado tiene mas resistencia al impacto o jalones y de manera vertical te va a salir bien la cara de superman y ya no vas a lijar mucho