UK 13Amp Plug Tester 3D print model

For use when Portable Appliance Testing UK 13Amp Plugs a handy quick way to test a UK 13 Amp plug.I printed using PLA Bed temp 65 Cooling to 60 After first layer

How to use:First insertplug in to the three pin holes if plug doesn't fit it fails to meet BS1363 standards.Plug must compleatly cover the bottom half marked Must cover this section if not the plug does not comply with BS1363.Large earth pin must fit the larger of the two slots thickness of tester is the same as the pin if pin more than 2mm short or longer it will not Meet BS1363 If the insulated pins do not fit the smaller slot and insulation does not line up with the line on the smaller slot it plug not comply with BS1363.