This is the kind of product that you say I don't know how I could live without it.
I was on my pc, and I had nowhere to put my headphones and the cell phone was always in the way. So I thought, I could put them both hanging on my CPU chase... But of course, I don't want to use glue or cut a hole to put something on my precious chase, right?
This simple and cool piece of plastic allows you to hang your phone in most places (chairs, beds, desk chases, drawers, etc).
But not only that, what if we can also use it standing up to put our phone in front of it, or even lying down to watch movies on the table.
With a fit that makes most 5' screens go in and out quickly and easily, and stays securely on it. It's what you didn't know you needed, but now you know.
Measures:
Maximum depth where to hang: 2.5cm
maximum phone width: 8.5 cm
recommended phone width:8cm.
maximum phone height: any, there are no limits.
maximum phone thickness: 1.7cm
recommended phone thickness: 1.2cm
Maximum width of headphones: 4.3cm
Maximum earphone thickness (at top bracket): 2.8cm
Overall Width: 3cm
Setting to pring:
It is printed without supports, in a lateral position as the model comes.
I recommend:
Nozzler: 0.4 (more detail and beauty, but you could also use a 1mm one)
Wall count: 2
Infill: >20% <35% (we don't want it to break, but we don't want it to be rigid so we can easily insert and remove the phone)
Speed: according to your machine.
Layer height: minor or equal 0.2mmhttps://youtu.be/_Y1hQu0C6yM
It is printed without supports, in a lateral position as the model comes.
I recommend:
Nozzler: 0.4 (more detail and beauty, but you could also use a 1mm one)
Wall count: 2
Infill: >20% <35% (we don't want it to break, but we don't want it to be rigid so we can easily insert and remove the phone)
Speed: according to your machine.
Layer height: minor or equal 0.2mm