Early Corinthian Helmet with Stand 3D print model

This product includes the following items.

1. Early Corinthian Helmet (Wearable)

• Helmet (one-piece version).stl
• Helmet P1.stl
• Helmet P2.stl
• Helmet P3-F.stl
• Helmet P3-R.stl
• Joint connection 1.2mm.stl
• Joint connection 1.3mm.stl**
• Helmet Stand**
• Stand Base.stl
• Stand Base (without Bottom Round).stl
• Stand Connection parts.stl
• Stand Top.stl

1. Crest (prototype)
2. Crest Left.stl
3. Crest Right.stl
4. Crest Horsehair Holder.stl
5. Helmet P3-F for crest.stl

6. Helmet P3-R for crest.stl

7. Transverse Crest (prototype)

8. Transverse Crest Front.stl

9. Transverse Crest Rear.stl

10. Transverse Crest Horsehair Holder.stl

11. Helmet P3-F for transverse crest.stl

This helmet was designed based on actual size artifacts.

The thickness of the helmet is approximately 2.8mm.

The helmet is divided into four parts: upper F/R, middle, and lower, and each can be combined using Joint Connection.

The filament (PLA) consumed when printing a helmet is approximately 450g, and printing takes approximately 63 hours.(Stand for helmet : 140g / 19h)

To print this helmet, your FDM printer will need a print volume of at least 200mm (depth) x 185mm (width) x 265mm (height).

Also, since the head size varies depending on the person, before printing this helmet, be sure to refer to the internal specifications of the helmet and adjust the scale to the size that suits you before printing.

This product also includes a unique stand for helmet mounting.

Crest is not originally included in this product, but it is a prototype currently under development, so we included it for free.

We recommend printing with a FDM printer.

Please look forward to the future products of BLUE SAND! Thank you : )

[Note]

• This helmet 3D model is not suitable for use on 12 inch figures even if reduced to 1:6 scale.
• Before printing this helmet, please use a slicer program to adjust the scale to fit your head size.
• The joint connection is for fixing the positions of the divided parts, so please use adhesive when joining the parts.
• Test printers : Raise3D pro2
• Test resin : Esun PLA+