ALIEN inspired face mask

ALIEN inspired face mask 3D print model

Description

this fan made ALIEN film inspired facemask was sculpted in zbrush and optimised for 3d printing using minimal amount of filiment and infill space. This mask was designed to wear over your covid fabric or sergical masks, cos lets face it... why be boring!??, or for cosplay, motorbike open helmets face cover, or whatever you decide to do with it! ;-)

*Disclaimer, this is not a protective mask and serves no filtration or protection. this is a mask for fashion and fun. the mask i am wearing has been airbrished myself there are no texture or colour files in this purchase. the drool effect is just hot glue dripped and rapidly cooled to create the effect of dripping drool.

files are in OBJ and STL and have been test printed

my suggested sizing is measured from the widest points of the cheek bones of the print.....

170mm for adult large faces 150mm for adult female or regular faces 130mm for small kids and small faces (these are suggestions... for the best sizing, measure the widest pounts of your face and match witht the mask.

ENJOY!!

R
rsmokey 2021-06-14 16:34:05 UTC
Hi there, would you still happen to have the GCode that populated with this item?
jarid88
jarid88 2020-09-22 04:49:48 UTC
Hi there! I'm nor familiar with cura, as I use S3D. But I would suggest on orientation that you print mask as it would sit on your face so, (right side up) if you will., slightly tilted up. Supports under the chin and jaw, and between the teeth (top jaw only as bottom teeth should not need supports if you understand the orientation setup I've tried to explain.
jarid88
jarid88 2020-09-22 04:49:46 UTC
Hi there! I'm nor familiar with cura, as I use S3D. But I would suggest on orientation that you print mask as it would sit on your face so, (right side up) if you will., slightly tilted up. Supports under the chin and jaw, and between the teeth (top jaw only as bottom teeth should not need supports if you understand the orientation setup I've tried to explain.
psycho-nextdoor
psycho-nextdoor 2020-10-02 01:03:19 UTC
i know you printed this on an FDM. what were your settings and material, if i may ask?
jarid88
jarid88 2020-10-02 04:42:03 UTC
Hi there! I printed it in pla+ on a creality ender 3. My settings were nozzle at 204 deg. Plate at 60deg. And fanspeed at 255. 3 Outer shells set to print inside to out. And 0% infill. I hope this helps.
Item rating
1 0
M
maxliam 2021-10-25 17:28:37 UTC
Recommended
magnifique faut juste que j'arrive a l'imprimé XD
ALIEN inspired face mask
$18.00
 
Royalty Free License 
ALIEN inspired face mask
$18.00
 
Royalty Free License 
Response 58% in 9.7h
3D Modeling
3D Print Modeling
Rendering
Hire meView all Designers Models

3D Model formats

Format limitations
  • OBJ (.obj, .mtl) (2 files)165 MB
  • Stereolithography (.stl)199 MB

3D Model details

  • Publish date2020-07-17
  • Model ID#2517040
  • Ready for 3D Printing
Help
Chat