ROBOT HAND - PRINT IN PLACE 3D print model

robot hand: print in place, but posable via the embedded tightening screws.

Slice with standard Cura PLA 0.2 mm layer / 0.4 mm noozle. No brim, No support (there are built in supports where needed). It fits on a small printer like my Artillery Genius.

First try to print the test double-09 joint (25 min). Remove the built-in support below the junction.

Check the screw can be unscrewed to unstuck it, then screw it down, with a small screwdriver.

If everything is stuck,try to reduce flow extrusion on your printer (i have to set the flow between 95% and 90% on my printer, depending on the filament).

Then print the hand (main-7.2, 9h00). It should print and come out of the bed without problems.

There are a couple built-in supports to remove on the thumb joints (easily).

Unscrew to unstuck, then screw to tighten the joints as you like. Make sure to push the screwdriver deep in the screw slit to properly drag it the first time. I had to make the slit rather thin to make the screw more robust. Be careful, dont hurt yourself! After these first turns, the slit will widen itself a little and it will be easy to engage the screwdriver.

If u liked the models just press like and comment, and i will post more awesome 3D files. Enjoy printing them and have fun!