Great model. I´ve found what I was looking
the model is very thin i suggest make it thicker
Купил не то что хотел. Задняя часть модели не проработана, фотографии с задним видом отсутствуют. Желательно модель при продаже показывать со всех ракурсов.
I didn't buy what I wanted. The rear of the model is not worked out, there are no photos of the rear view. It is advisable to show the model when selling from all angles
As I am completely new to the realm of 3D printing and the associated technology, I blame myself for not recognizing the fact that the is a relief. There is no "back side". As a result, it will be required of me to make another purchase. I don't know if I missed any indication that the model was just a relief; but, in my opinion, it should have been made obvious!
Other than that, it's too early to determine how I will think of the purchase until after it's been printed.
hello what program did you use to create this? I have rhino. I need it to be 19.54mm hand to hand.2.11 thick and approximately22mm tall. can this be manipulated?
