Giger Mask 3D print model

I don't know how you manager to print it, it just needs to be made solid instead of a hollow shell. you end up using twice the filament that you should need to, 2.5 rolls by the slicers estimate. I attached a picture to show you what I mean. if it were solid then you could just add infill and use much less filament/supports. There are a few hollow places where the bode meets the base that you would never get support material out of as well. https://i.imgur.com/M1mcIi6.jpg

uploaded some new files

How can I see these? I tried re-downloading from my purchase screen and its the same model as before.

try again. Been awhile since In on this interface

So much better for printing now, thank you for making it a solid for me! :D This cut the time to print down and the amount of filament almost in half.

no problem! glad it worked out

This model needs a lot of work to make it printable, the whole base is messed up when put in a slicer. it hollow, plus parts of the top disappear altogether. lots of non manifold areas too. If I knew it was like this I would not have paid the asking price for it.

odd, I was able to print fine with it, but it was for a powder bed. I feel bad, I can sealed up the hole and upload another version. Is Just a decimated Zbrush model and seem to work fine when I print

Excellent work, I love the head sculpt in particular :)

Thank you!