Fantasy lamp 3d print 3D print model

I printed on fdm Sidewinder x1 printer

I like the model, you can make a candy out of it, print the central cylinder with transparent plastic and put a light source inside, in general I think you can make the model interesting, my job is to test the model, I would like to see a painted model with a light inside, I wish you success

you don't need to sand anything, you need glue.

Model content:

Fantasy-lamp-handle-part-1(54mm)

Fantasy-lamp-handle-part-2(92mm)

Fantasy-lamp-handle-part-3(89mm)

Fantasy-lamp-part-1(125mm)

Fantasy-lamp-part-2(95mm)

Fantasy-lamp-part-3(94mm)

Fantasy-lamp-part-4(75mm) - should fit perfectly into each other, with a cylinder, if there is a small gap then you have confused the parties

Fantasy-lamp-part-5(76mm) - should fit perfectly into each other, with a cylinder, if there is a small gap then you have confused the parties

Fantasy-lamp-part-6(53mm)