DRAGON PENCIL CUP 3D print model

The Improved tree supports now use less material and print faster, making them easier to remove and resulting in a cleaner final print. Also a big shout out to community member @ThomasRahm who originally proposed and created these new improvements.

You can use this model to test the newly introduced settings:

Maximum Branch Angle

Trunk Diameter

Branch Diameter

Branch Diameter Angle

Preferred Branch Angle

Diameter Increase to Model

Minimum Height to Model

Initial Layer Diameter

Branch Density

Tip Diameter

Limit Branch Reach

Optimal Branch Range

Rest Preference

Cura Setting ValueGenerate Support YesSupport Structure TreeMaximum Branch Angle > 40 °Branch Diameter 5 mmTrunk Diameter 25 mmBranch Diameter Angle 7 °Support Placement Touching BuildplatePreferred Branch Angle 27 °Branch Density 10 %Tip Diameter 0.5 mmLimit Branch Reach YesOptimal Branch Range 30 °Support Overhang Angle 60 °Support Density 0 %Enable Support Brim YesSupport Brim Width 0.75 mmSupport Brim Line Count 3Support Z Distance 0.2 mmSupport X/Y Distance 0.7 mmSupport Distance Priority Z overrides X/YMinimum Support X/Y Distance 0.2 mmMinimum Support Area 0Enable Support Interface NoFan Speed Override No