Cheetah running intended for 3D printing 3D print model

Model is created in Zbrush. Model is watertight.

Obj and Stl files are provided.

Model is separated into base and cheetah. There are two variations one with grass and one without the grass just one contact point.

Model is 12.5 cm long from tip of nose to end of tail. But you can easily resize it in any 3d software that you are using.

Model is not pre supported.

I hope you like the model. If you need any help with the model feel free to contact me. Please rate if you like the model.

I printed this model on my Anycubic photon mono,using 0.05 layer height. Bottom layer count 4, lifting distance 8.000 mm all other settings were defaults. I used chitubox free slicer. For supports I used mix of automatic and manual supports. Your settings will depend on your printer, these were the ones I used.

Happy printing !!