AI-Ball figure of Marco from AINI. Includes Pleading and Normal variations, alongside an older Normal variation that doesn't actually match Marco's model, but I figured I'd add it in anyway.

Personal Recommended Cura Settings:

Walls:

• Wall Thickness: 1.6mm

Infill:

• Infill Density: 10%
• Infill Pattern: Lines

Support:

• Support Placement: Everywhere
• Support Overhang Angle: 60-65 degrees
• Support Density: 15-20%
• Enable Support Interface
• Enable Support Roof
• Enable Support Floor
• Use Towers

Build Plate Adhesion: Raft

Angle: It is recommended to print these files at an angle where minimum support is required, while being enough to prevent the print from failing. I tend to print Marco at a slight angle, with zir head on the build plate (like ALMOST upside down, but not completely). This makes it easier to remove the support underneath zir arms without breaking them.

Copyright: This is PERSONAL USE only. You cannot sell the file or print and sell the figures.