KRATOS SWORD CHAOS AND WALL PLAQUE 01 3D print model

The 3D model is prepared and ready for 3D printing. Printing test performed on Creality LD-006 printer. Contents: STL file.

Total de Pieces: 4Approximate Plaque Dimension: 150X150mm

If possible share the impression and painting you made of the file.

Tip for a good impression:

Make sure your printer is calibrated Use the correct timing for your resin/printer After printing, wash the piece and remove the supports by hand or with the aid of pliers, remove carefully Cure your parts Finish your piece with sandpaper Paint your piece and make your collection. Thank you very much. Hope you like it! ;D

Thank you for downloading and supporting! Please remember to rate my work ! thanks!