STEN MkII 3D model

Full assembled model of STEN Mk.II and 9mm Luger bullet.

Model is good for weapon mechanic animation, games and for visual education.

Notification: if You need low poly model You can contact me here or : 27608166@mail.ru

The Mark II was the most common variant, with two million units produced. It was a much rougher weapon than the Mk I. The flash eliminator and the folding handle (the grip) of the Mk I were omitted. A removable barrel was now provided which projected 3 inches (76 mm) beyond the barrel sleeve. Also, a special catch allowed the magazine to be slid partly out of the magazine housing and the housing rotated 90 degrees counter-clockwise (from the operator's perspective), together covering the ejection opening and allowing the weapon and magazine both to lie flat on its side. The barrel sleeve was shorter and rather than having small holes on the top, it had three sets of three holes equally spaced on the shroud. To allow a soldier to hold a Sten by the hot barrel sleeve with the supporting hand, an insulating lace-on leather sleeve guard was sometimes issued.[14] Sten Mk II's in German possession were designated MP 749(e), the e signifying englisch. Some Mk IIs were fitted with a wooden stock as this part was desirable and interchangeable with the Mk V. Also, the Spz-kr assault rifle uses the receiver and components from the Sten Mk II.