HANSGROHE Set 4 Ecostat Raindance with adjustable watering can 3D model

The archive includes a set of 7 objects of HANSGROHE shower systems, here each element is named separately :

1. Raindance E 360 1jet Showerpipe with thermostat for bath;
2. ShowerSelect ShowerSelect thermostat, for 2 consumers, SEE;
3. Ecostat E Shower thermostat, VM;
4. Croma 100 Vario Shower set with 65 cm barbell and soap dish;
5. Raindance Select E Hand Shower 120 3jet EcoSmart 9 l / min;
6. Raindance Select S 240 2jet overhead shower with holder;
7. Raindance Select S 240 2jet overhead shower with ceiling connection;
8. Raindance Select S Hand Shower 120 3jet PowderRain;
9. Ecostat E Thermostat for bath, VM;
10. Unica Shower rod Croma 65 cm with hose;
11. Novus Loop Bidet faucet 70, single lever, with drain set;
12. Novus Loop Sink faucet 70, single lever, with drain set;
13. Novus Loop Sink mixer 100, single lever, with drain set.

In this archive, you can adjust the position of the watering can with a rod, in any direction, for models with flexible hoses:

1. Select the model you want to use,
2. Copy and place it in your scene;
3. The model needs to be ungrouped;
4. Click on the watering can or bar, move it in the desired direction. In this case the hose will smoothly change its position following the rod with the watering can;
5. If you are satisfied with the height of the watering can, go to point number 6. If you need to raise or lower the watering can, you must also click on the watering can, unpack it again and then move it up or down;
6. After all the manipulations done, you can translate the model into Editable poly.

Move the watering can within reasonable limits, because the mesh is stretched and the hose loses its shape.

Vray version 3.20.03Corona Version 1.7

Polys: 252447Verts: 293857

Stage organization:

• all objects are assigned names in the scene;
• real world size (system blocks - mm);
• all previews are rendered in 3ds max Vray;
• the model is fully ready to use visualization in 3ds max + Vray+Corona.

https://www.hansgrohe.de

Who works in V-Ray version lower than 3.1 be careful, in the materials in the BRDF section there is a Microfaset GTR ( GGX ), if your version is older than 3.1, then the BRDF field will be empty. Choose Blinn, Phong or Ward – which is preferable for you

For Corona render, it is recommended to install a version not lower than 1.5, since the glossiness of the materials is configured with PBR in mind.