Star Wars - 181st Tie Pilot Type A Chest Box 3D print model

According to the 501st requirements:

• Two diameter circular are 18mm
• The squares are 25.4 x 25.4mm, and thickness is 0.8mm that sticks out
• Interlockable parts, no need to worry about loose parts when transporting it.
• The hole for the audio jack has an opening of 3.5mm hole.
• The side hose connectors has an opening of 37mm hole
• The middle hose connector has an opening of 37mm hole
• It has 4 rectangled holes that accepts nylon webbing width of 24mm.
• At the back you can see it's hollowed out, dedicated for storage such has trading cards

For better quality printed parts, print the audio jack and male snap in resin on a resin printer. Better yet, use the real counter parts used in audio jack ports and a snap from a snap kit DIY or bought separately at a hobby shop.

Lid V2

• The flat area of the lid has been updated. There was a modeling flaw where the bottom surface wasn't even and could potentially result in an error or failed print.

If you want a 3D printed DIY kit of this, then take a look at my Etsy webshop:

https://www.etsy.com/nl/shop/XekroPropShop?ref=seller-platform-mcnav

The files has been thoroughly researched and looked at. Some minor details might be a Designer error. I have printed most of the armor (if for some reason you've found errors) please point it out and I will update the files LIFE LONG service accordingly to your feedback!

Feel free to message me for support!

Check out my other listings if you wish to purchase parts individually!

**3D Files are meant as personal use and not to be sold as 3d files.

PM me if you wish to vendor finished commissioned pieces or 3d prints!**