Pedal Cleat Tool For KEO Look 3D print model

Hi Adrian, I bought this design yesterday, together with the SPD version (feedback on that design too). The model was too large for my Ender3 build plate, so I took the F3d and cut it in two to print. I used a dovetail connection to easily assembly and disassembly for storage. I had to dremel the bottom side of the Keo cleat gap a bit to make it fit correctly. I added some white painters tape to the surface to mark my Keo cleat position (read the Ergon TP1 instructions about marking your 'toe joint line'.) On the bottomside I did the same thing for the other shoe. Does the job perfectly and much cheaper than the Ergon tool I was looking at.