Boba Fett Dented Helmet ready to print movable range finder 3D print model

This is my version of the Dented Boba Fett Helmet

The range finder moves and is held up with 10mmx3mm magnets. The ear cap is held on by magnets as well. These magnets can be found cheap on amazon or the ear cap can be glued. I've included a solid and a hollow range finder shaft.

This helmet should print just fine with zero supports in the center and fit on a 300x300 bed.

I tried to make this as close as possible size wise to the original used helmet and will be comparing it side by side to an early generation casting to make small adjustments.

Please, Do not share/resale the 3d model

I don't mind selling of the prints as long as GrizzlyMountainDesigns is refered as the modeler :) Please feel free to message with any other questions or reguests! for even better deals, check out our patreon at patreon.com/grizzlymountaindesigns

If you like my designs/models check out our instagram Grizzlymountaindesigns or for even better deals then on here join the patreon, same name!

I do custom models so let me know if there's anything you think would be a good hit!