K
2023-12-10 19:54:06 UTCkarlu
Cool
Useto navigate. Pressescto quit
Saitek Rudder Pedals to Cessna Conversion 3D print model
Description
Convert your normal Saitek Pro flight rudder pedals to Cessna rudder pedals by simply unscrewing the original pedals and replacing them with your own 3D printed Cessna pedals.*Base not included with STL file only the rudder pedals.
Recommended print settings:High Quality:Infill - 25%Wall count - 3 (0.4mm nozzle)Top & Bottom layers - 6Layer height - 0.2mmAt least 200mm x 200mm build plate requiredSupports - required (only necessary for bottom notch) - enable for overhang more than 85°Required filament - +- 90 meter / 266 grams per Pedal
C
2023-02-15 22:34:37 UTCcrayon97
Nice
N
2021-09-22 05:22:53 UTCnanda-sumedang
Good job
polypropstudio
nice
H
hectorfdz
Great! fast, I have printed in CA for just $46 usd with shipping using PETG material.
A
a777driver
Great replacement for Logitech rudder pedals. However, the screw holes were about 1/64 in. too small I needed to be drilled out.
T
tampabaybutterfly
Great model. Perfect size for the Saitek Pro Flight rudder pedals. The only problem I had was the mounting holes were too small and would not accept the screws, so I had to drill out each hole (with the drill on the slow setting) with a drill bit 1/64 larger than the holes, being careful not to bust through the bottom, so I could slide the screws down into them. This took a while to do and it required a lot of clean-up afterwards. If the holes going through the pedal were 1/64 larger, this model would've fit perfectly without any post-processing.
J
jpaudet310
I m happy with the service. I am anxious the see the final result of the printing.
S
streaks
Similar Models
to Saitek Rudder Pedals to Cessna Conversion
