Side Car and Buggy for Transformers SS86 Wreck Gar 3D print model

After doing up the extra wheels for Wreck Gar ( https://www.patreon.com/posts/61400787 ), it somehow inspired a larger addon vehicle in the form of this side car and buggy!

Since it uses a quartet of the Wreck Gar wheels, it will connect right up alongside him in his alt mode. This should sit most legends scaled bots pretty nicely unless they come with some weird back kibble.

5mm ports have be placed around the buggy so that you can attach weapons to beef up this bad boy, or use them to have effect parts mounted on:

For the rear piece, there is a variant so you can choose to either have a standard piece which sports a pair of 5mmn ports, or one which has an Autopod hitch connector designed in (the one with the gap).

With the Autopod version installed, you can hook up the trailer from the Autopod series ( https://www.patreon.com/posts/55624767 ).

But that's not all! This same rear piece also can be flipped around, to become a turret mount for any weapons or accessories which you would like to mount on, converting the buggy into a drone of sorts.

And just to add on a little more fun to use any titan masters you might have, there's a little hidden compartment under the seat in the buggy, where a small titan master crew seat is stowed. And with a Titan master placed upon this, the crew seat can be magnetically attached to the front of the flipped up turret mount!

=== ASSEMBLY ===

As usual, here's the build diagram for this piece:

Some things to note:

• The main body is comprised of the Left, Middle, and Right pieces, held together with a bunch of 5mm peg, which have been provided as 3d printable pieces too. From front to back, the lengths and quantities required are : 1 X 10mm length , 1 X 35mm length, 2 X 42mm length.

• The swiveling Chair piece attaches to the body using the Peg-Rear pin.

• It would be advisable not to glue the body pieces together if they are snug enough, so that the chair piece can be swapped out as you like.

• For the Chair_Hitch piece, the Peg_Hitch needs to be inserted into the rearward 5mm hole to make the vertical post for the Autopod trailer to hitch onto.

• A pair of 5mm (diameter) x 3mm magnets will be required for the Chair and TM_Seat parts to make for the magnetic snap action.

===Phew, hope y'all will have as much fun messing around with this with your bots as we did putting it together! Vroooom vrooom~ =P

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog