Grappling Hook Launcher Kit for Transformers Legacy Sandstorm 3D print model

With the fun rescue cage accessory we got with Legacy Sandstorm, we wondered if that too could transform into another type of addon! So behold - a grappling hook launcher kit!

This kit comes with walls, doors and top cover to transform the cage into a missile pod! The winch simply sits attached on the floor of the pod.

With the handy fact that Sandstorm's tail rotor piece can be detached, it is connected to the peg at the end of the winch's rope. Tada! Instant grappling hook (which needs to be removed for the doors to close though :P)

Being a less-mentioned member of the Wreckers, we imagine that this would help the crack team infiltrate many a well guarded Decepticon outpost!

Using the winch's 5mm peg which extends through the hole in the floor piece. This can attach onto Sandstorm's forearm! Admittedly, there peg is not very long in this mode, so a little bit of balance may be required.

As usual, we popped on a 5mm port on the rear side for effect parts to be used. All that back blast would have to go somewhere ;)

=== Assembly ===

The attached diagram shows the parts of this kit and how they are supposed to go together.

===

Hope y'all enjoy this kit to allow an alternative use to Sandstorm's rescue cage accessory. Happy 3d printing as always! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog