Gap Fillers for Transformers WFC Kingdom Megatron 3D print model

Getting the Beast Wars characters back again in the main line was such a nostalgia blast, after over 20 years of waiting! Megatron in this line was again a major character whose engineering does such justice to the character! Yessssssssss....

But as a slight nickpiticky annoyance, he does have a fair amount of hollowed out parts in his figure. Totally understandable due to the cost factors which does have to give into our figures these days - so here's our little take at trying to remedy it though!

Attached is Megatron in a classic Zoidberg pose to show where the filler parts go. Left side thigh for a before look and right side thigh for how things look after the fillers have been added in. There is also a singular filler piece for the underside of the right forearm.

With fillers installed in both sides , Megatron will be a little more wholesome!

Also here is a quick render showing the parts. To make things a little easier when it comes to printing the smaller filler bits, they have been combined into a single file. A little tip if you have issues printing the smaller parts would be to reduced your print speed a tad. The hollow in the thigh is sized as a standard 5mm port.

===

Have fun fleshing out the hollow bits on Beast Megatron with this set! =D

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog