Containment Pods from Transformers Netflix WFC Earthrise 3D print model

One of the more morbid parts from the Netflix WFC Earthrise chapter was the Decepticons' capture and draining of the sparks from many of their own in these Containment Pods which lined rows and rows in the Decepticon Arena!

A very interesting design to say the least - and so let's modify the original BioTank display (https://www.patreon.com/posts/28488496) to replicate it! This is a pretty straightforward model to put together, though due to its size (to be able to hold a figure inside) are rather large.

From top to bottom, the parts needed are:

• Top_Main with the Top_Plug piece in it.
• Top_Quads x 4, which are connected to Top_Main piece using optional 5mm pieces
• Ring piece, with Module1x2 and Module2x2 attached to them
• Wall - either 1 piece to create a cutaway as shown or 2 for an enclosed pod
• Either Bottom_Solid or Bottom_Whole

Or, as an alternative, a clear acrylic tube of about 120mm diameter can be used instead for a clear see-through look.

Inside the Top_Plug piece, there is actually a hollow sized to allow one of those electronic tea-light candles to be placed in there to provide illumination from the top.

Unfortunately, couldn't seem to find any around, but the previous BioTank posts should give and idea of how it would look with the lights (which can also be used in the base piece with the hollow) - https://www.patreon.com/posts/28488496

Hope this piece helps to jazz up some of your bots, especially if you are putting together a Netflix WFC themed display/section! As always, happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog