lasthawk
awesome
Useto navigate. Pressescto quit
Midgard Serpent Dice Tower for 3D-printing 3D print model
Description
Jörmungandr, the dreaded Midgard Serpent, wrapped around a rock.
This sculptural Dice Tower (recommended minimum height 20cm 7.9 inch) will make the centerpiece of your gaming table.
The Dice Tower easily fits 9 14mm dice when printed at recommended size and can therefore be used for TTRPGs, Wargaming as well as most boardgames.
The Tower comes in 3 variants.
The full model to give you all liberties.
The full model hollowed and fully supported for resin 3D-printing, just as we use it in our own physical production.
The model split into a total of 14 parts to fit smaller printers.
All of our models are designed for and tested on resin 3D-printers.
A
arhcangel923
File is beautifully sculpted, however for those on smaller printers. If you are printing this file in the separated parts, the pieces have a bit of a hard time going together and will require sanding and carving with an exacto knife. Additionally the split up file is drastically scaled down from the original size and will not be able to fit any dice inside of it unless it is scaled up
K
kazaar13
The model looks great. I printed this on my X1 Carbon. I had to scale the imported file up to 200+mm to get the correct size as it was imported in cm and was tiny. It took about 28 hours to print and I am getting ready to clean off the supports. I see no defects and the model looks very nice. I can't wait to try this.
Similar Models
to Midgard Serpent Dice Tower for 3D-printing
Users who bought this item also bought...
