Sword and Shield Gym Leader Ball Holder

Sword and Shield Gym Leader Ball Holder 3D print model

Description

Created this ball holder to go along with my Sword and Shield cosplay. I first made it to be compatible with the Clip N' Go system [affiliate link] https://amzn.to/37jhnUj. I then decided to make individual balls as solid models and hollow ones that could be glued together then secured.

In total, there are three different back plates. Two of these loop over the side of one's pants. The other has a hole at the top for affixing to a belt. Because of the weight, it's advisable to secure these back plates to a belt under one's shorts, in general.

There are two front pieces that hold the balls. One of theses pieces has sections where balls can be snapped into place. The other front piece has holes where a screw can be used to affix the ball to the front plate.

Both the front and back plate are secured to each other with a 1/4 inch (6.35 mm) in diameter screw post.

The entire model, when assembled, measures approximately 203 mm x 139 mm x 82 mm.

Item rating
0 0
Sword and Shield Gym Leader Ball Holder
$3.00
 
Editorial No Ai License 
Sword and Shield Gym Leader Ball Holder
$3.00
 
Editorial No Ai License 
Response 100% in 0.4h
3D Modeling
3D Print Modeling
Hire meView all Designer's Models

3D Model formats

Format limitations
  • Stereolithography (.stl) (8 files)5.14 MB
  • OBJ (.obj, .mtl) (3 files)1.46 MB
  • Autodesk FBX (.fbx) (3 files)1.01 MB

3D Model details

  • Publish date2019-11-19
  • Model ID#2165138
  • Ready for 3D Printing
Help
Chat